The Hand Held Programmer is designed for use with all analog sensors and modules.

Address Setting
1. Install sensor onto programmer, ensuring that sensor protrusions align with programmer grooves.
2. Press the left gray button to switch programmer on. A battery check message will appear followed by the device’s address (Unprogrammed sensors will read address 127).
3. Set the required address by incrementing the left and right gray buttons (the display will show three red flashing dots if the address being programmed is different from the device’s current address).
4. When the desired address is present, press the blue button to store that address. The three red dots on the display will no longer be present.
⇓ Tải xuống Catalogue